DIY Stained Glass Looking Ornament #KidsDIY #DIY #Christmas


I have always loved the look of a stained glass window and I like to find different ways to make a stained glass look to my craft projects. This is no exception, I tried to find a easy way for children to make stained glass looking ornaments for the Christmas tree. We make a lot of our ornaments for our tree together as a family.


This is a perfect ornament for the family to make together and you can make the designs any way that you would like. Your not limited to the designs that can be made with this ornament. I made this one a little simple so that it would be easier for the real little ones to take part in. They come out so adorable and so pretty when the Christmas lights twinkle on them. It just creates a beautiful stained glass look when the lights are on.


* Ceramic Tile (Lowe’s Item #
* Alcohol Ink (I used Red, Blue, and Green) you can use whatever colors you like
* Alcohol Ink Applicator pads
* Twist tie from garbage bag
* Chalk board vinyl (Get in School Supplies aisle) or black Vinyl at craft store for wall decals
* Modge Podge
* Plastic gloves (Dollar Tree)
* felt (I get the felt 4/$1) at Craft store
* Metal D Ring hangers for hanging pictures
* Hot Glue gun and glue sticks
* Ribbon

Step 1: Cut very thin strips of Black Vinyl you will need 3-5 strips per ornament

Step 2: Measure how much vinyl your design will need as you design it. You will push down with your thumb where you want to cut the vinyl against your ornament. Then cut so that you have enough vinyl to make your design.

Step 3: remove the backing off the vinyl and place them where they will go on your ornament. If your making the same design as I did it will be an X with a strip through the middle.

Step 4: You now have your outline of where your going to go with the Alcohol ink. Alcohol ink dries quickly! So you will want to have your twist tie pushed in half and then bend the bottom of the twist tie so that it’s a little flat to help you use it with the application pad to get it in the areas that you would like them.

Step 5: Put your gloves on and you are going to want to dab the alcohol ink in the areas you want them. You do not want to keep the ink placed on the ornament or it will run into the other areas. So you want to be sure to dab and continue to the areas colored.

Step 6: Continue to ink the areas as well as the sides of the ornament. Once they are done you will let it dry for 10-20 minutes.

Step 7: Now you can open your modge podge and use a foam brush to dab on your modge podge. You do not want to brush it over or it will take the ink off again. The modge podge will seal the ink and keep it on your ornament. Now you will allow it to dry for about 20 minutes moving the ornament every 5 minutes to make sure it doesn’t stick to your work surface.

Step 8: You will trace the ornament design onto the felt that you will use for the back of your ornament to cover it. You will need to do a little trimming to get it down to where you would like it to be and not show around the edges of the ornament when your looking at it.

Step 9: You will now hot glue the D ring hanger to the back of the ornament. Let it sit for a few minutes to ensure it has enough glue.

Step 10: Now you will hot glue your felt in place on the back of the ornament. Again let it sit and cool.

Step 11: You will now take some Ribbon and cut it as long as you would like the ornament to hang on the tree. Now you will tie a bow so you can hang your ornament.

Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *